Answer (1 of 8): Your automobile will probably feel a smoother shift while shifting gears, lubrication capabilities are there, if it doesn't make strange noises, then I would not worry about it. Many good shops use automatic transmission fluid when they have shifting issues. Furthermore, some aut On the left of the transmission is the fill plug, and on the right of it is the drain plug. Place the drain pan under the drain plug, and slowly loosen it. Expect the fluid to come out strong, and weakens as it drains, so place the drain pan accordingly. Tighten the drain plug when it's done draining. Figure 1. The Vibe, like most manual transmissions) sets the full level as the bottom of the fill hole. Basically fill it up till it starts to come back out, let whatever wants to come out come out, then it is full. (That's why being on a level surface is important)6. Replace the fill plug, 7. clean upAs for which gear oil to use, the owner's manual If you have an oil gun, you can fill it with the transmission fluid and connect the hose to the transmission port so that the fluid will flow in without your effort. But it doesn't matter, and you can use whichever you have. Immediately after the car starts, you will notice a high flow of fluid from your transmission lines. A rough estimate of maybe 3ft-5ft of that should be good. 2. Locate the Check/Fill Plug and once located remove with a 17mm socket. If you'd like dip your finger in there to see what the fluid looks like. 3. Analyze the plug & finger to see if it's dirty and that the fluid needs to be replaced. Therefore, a big part of selecting the right transmission oil is to find the compatible oil. This can be done by knowing the GL rating of gear oils. The most common GL rating is GL-4 and GL-5. GL-4 is typically used in regular cars for daily usage. The GL-5 is recommended to high-stressed gearboxes in trucks and high power output cars. What fuilds do i use in a jeep 1995 wrangler 5 speed manual transmission also what to use in transfer case every tells me something like using 10w30. You can use 75W90 gear oil or 10W30 motor oil for the trans. I would use full synthetic for whatever one you choose. I would only use ATF or ATF+4 in the transfer case. Choose the brand you like. Where Do You Put Gear Oil In A Manual Transmission Author: spenden.medair.org-2022-07-07T00:00:00+00:01 Subject: Where Do You Put Gear Oil In A Manual Transmission Keywords: where, do, you, put, gear, oil, in, a, manual, transmission Created Date: 7/7/2022 2:35:33 AM 4. Once the fill plug is out, position the drain pan on the floor under the drain plug on the lower right side of the transmission housing and remove the drain plug being careful not to drop it into the drain pan. 5. Once all the oil has drained, replace the drain plug and tighten with the 8mm Allen socket. 6. Replace the drain plug to a snug fit without over tightening or stripping it. Place the pump hose into the fill hole and pump in the transmission fluid without overfilling it. Insert the filler plug and tighten it by hand. Then, tighten it further to a snug fit with the wrench. Figure 6. Insert the pump hose into the fill hole. Step 5 - Test drive Where Do You Put Gear Oil In A Manual Transmission Author: support.wagingnonviolence.org-2022-06-28T00:00:00+00:01 Subject: Where Do You Put Gear Oil In A Manual Transmission Keywords: wh