Time to install the new bottom door seal. One end of the seal will have a small notch in the side. This is the side that needs to go on the right with the notch going into the door. Lay the new seal down at the bottom of the door and ensure the end is properly lined up. Work the new seal under the door by hand, starting from the right hand side. • Take off the outer door seal retaining band or spring with the help of a flat blade screw driver, and peel the seal of the lip, and tuck it inside the drum. • Remove the two screws that hold the lock • Unscrew the three screws at the bottom of the facial panel, and now you are ready to release the front facial panel of the chassis. washing machine door seal replacement instructions By | February 14, 2021 | 0 | February 14, 2021 | 0 1 - Disconnect the power on the Bosch, Neff , Siemens or Balay appliance. Make sure you're unplugged from the mains before you do any work on an electrical appliance. 2 - Remove the lid on your Bosch, Neff or Siemens washing machine. 3 - Remove the tension ring under the rim of the seal at the front All groups and messages this video will show you how to remove and replace the door seal on a beko washing machine, this does not apply to all beko models!applies to WM, WMA, WMC, W Replace the lid, ensuring all screws are tight, before checking that the door seal is correctly fitted by making sure that the door closes properly; if it does you are pretty much there, all you then need to do is put your washing machine through a rinse cycle to ensure that there are no leaks. How To: Replace the seal to a washing machine door By dav1224; 7/22/10 9:42 PM; WonderHowTo. A leaky washing machine is a problem that should be addressed quickly. Any access water leaking out of your machine can cause your floor to be slick and possibly create a mess, especially if you have carpet. 6. Apply liquid dish detergent to your fingertip. Insert your finger into the groove that runs through the new boot seal's perimeter and spread the soap throughout the groove -- this helps Two screws at back will remove the lid of the washing machine. The facial panel will have to be removed this varies from model to model, so see our video on basic technique. Remove the front retaining band and peel the seal of the front panel. Remove the two screws that hold door lock in place. Step 1: The idea for the replacement is to basically remove the top and then front panel, and then remove the old door gasket and replace the new gasket with the drum in place. Remove all the sheet metal screws that are holding the top cover down. Slide off the top cover and then remove the screws as shown by the screw driver in the photo. Feel the outer and inner retaining clamp. If the ring is made of plastic. find the latch, loosen it with a screwdriver and pull the rim forward. When the clamp is metal, you will have to unscrew the screw and catch the spring with a slotted screwdriver; Remove the fixing rings from the machine; Feel the outer and inner retaining clamp. If the ring is made of plastic. find the latch, loosen it with a screwdriver and pull the rim forward. When the clamp is metal, you will have to unscrew the screw and catch the spring with a slotted screwdriver; Remove the fixing rings from the machine; Step 3: Remove the Outer Rim of the Door Seal. Remove the metal spring which goes round the