Only suitable for manual aiming. P/N: 28740034. Camera Target 210mm x 240mm - 2 Pack. Black and white target on hard plastic. P/N: 55001469 Replacement power supply and regional specific power cord for the Trimble dual slot battery charger. P/N: 101071-00-XX* *XX denotes power cord region: 01 = North America 02 = Japan 04 = Europe 08 = UK When the rechargeable Lithium-ion battery is delivered, it is partially charged. Before using the battery for the first time, charge it completely. Use only Trimble battery charger (not included) approved by Trimble. Refer to the Trimble SX12 Scanning Total Station user guide and the Battery charger user guide for more information. - Charge the Lithium-ion battery only in a Trimble product that is specified to charge it. Be sure to follow all instructions that are provided with the battery charger. - Discontinue charging a battery that gives off extreme heat or a burning odor. - Use the battery only in Trimble equipment that is specified to use it. Trimble Battery Charger - Dual Slot for GPS and Total Stations - New, P/N: 109000. Compatible with: All Trimble GPS & GNSS receivers: R8 (all models) R7, 5700, R2, R4, R6, R10*, R12* SPS985 & SPS986, SPS780 through SPS882, Batteries: 92670, 54344. Trimble Dual Bay Charger for GPS and Total Station Batteries, R10, S6, SPS985, R8 | 109000; Trimble s6 battery charger parts manual pdf The Extended size cabinet also supports housing up to 2 batteries (depending on model) and a GNSS receiver such as the Trimble NetR9 Ti-M. Specification Sheet P/N: SETTOPM1CAB_BIG-MON Adapter for Pillar Plate, Pole and Wall Console Ring with base protection plate for direct mounting at pillar plate with groove (PN 1510011-02-MON), at the Use the battery only in Trimble equipment that is specified to use it. To protect the removable Li-ION batteries from extreme temperatures, the battery charger only operates in the following temperature range while connected to an external DC supply: +5 °C to +35 °C when powered by external DC supply while actively charging the battery. Trimble R2 GNSS Receiver Getting Started Guide Version5.22 Revision F October 2017 TRIMBLE R2 GNSS RECEIVER USER GUIDE Corporate Office Trimble Inc. 935 Stewart Drive Sunnyvale, California 94085 USA Geospatial Division Trimble Inc. 10368 Westmoor Drive Westminster, CO 80021 USA trimble.com Email: trimble_support@trimble.com Legal Notices - Charge the Lithium-ion battery only in a Trimble product that is specified to charge it. Be sure to follow all instructions that are provided with the battery charger. - Discontinue charging a battery that gives off extreme heat or a burning odor. - Use the battery only in Trimble equipment that is specified to use it. 5. Close the SIM card slot cover, and replace the battery. Slide the battery lock to the locked position. The tablet computer will not turn on if the battery lock slider is not locked. Inserting a battery 1. Insert the battery (standard or extended) into the battery compartment in the back of the tablet computer, as illustrated: 2. - Charge the Lithium‐ion battery only in a Trimble product that is specified to charge it. Be sure to follow all instructions that are provided with the battery charger. - Discontinue charging a battery that gives off extreme heat or a burning odor. - Use the battery only in Trimble equipment that is specified to use it. 4 Trimble TS862 and TS835 Total Stations User Guide WARNING - Do not cover