Mount body using the two stringer mounting holes (3) on the bracket. Note: Remove cover (4) to access mounting holes. Make sure the word "UP" (5) is on top of the valve body when installing. A.Distance (1) from the stringer (2) to the front of the plasterguard is 2 3/4" ± 1/4" (70 mm ± 6 mm). requerir RP47202. B C The figure illustrates the diverter and MultiChoice installed in the same finished wall. Note: Refer to the diverter rough installation instructions for more information. C DIVERTER La figure montre l'inverseur et la soupape MultiChoice installés dans le mur fini. Note : Consultez les instructions d'installation de RP47202 Thin Wall Mounting Kit Soporte de montaje fino de la pared Support mince de mur *Used to plug one inlet side (Hot or Cold) to prevent cross flow when checking for leaks before the cartridge is installed. Inset into the inlet, place test cap and use the bonnet to secure in placr e. Read all instructions prior to installation. ! CAUTION. Failure to read these instructions prior to installation may result in personal injury, property damage, or product failure. Manufacturer assumes no responsibility for product failure due to improper installation. Note: For thin wall installation, RP47202 might be needed. The instructions that came with this valve are pretty slim. This would be a "thin-wall" installation as they call it, but they omit the details. The attached plasterguard is secured to the valve with two screws at diagonal locations. There are also two empty diagonal screw locations where I assume the escutcheon cover installs. A. INTERROMPEZ L'ALIMENTATION La figure montre l'inverseur et la EN EAU. l'avant du protecteur est de 2 3/4 po Déterminez le type de la paroi et son épaisseur totale avant de placer la plaque arrière. Installez le corps (1) de sorte que la surface du mur fini soit à égalité avec l'avant du protecteur (2) ± 1/4 po. instructions d'installation dans un mur mince qui se trouvent sur le sac. Note : Dans le cas d'une instal-lation dans un mur mince, le kit RP47202 peut être nécessaire. B. C. The figure illustrates the diverter and MultiChoice installed in the same finished wall. C. Note: Refer to the diverter rough installation instructions for more Kitchen and Bath Faucet Replacement Cartridges and Stems. Shipping Dimensions. 4.88 H x 2.13 W x 1.25 D. Shipping Weight. 0.125 lbs. Return Policy. Regular Return (view Return Policy) Please Note: Prices, promotions, styles and availability may vary by store and online. PRESSURE TESTING & FLUSHING THE INSTALLATION Prior to testing, remove cover (1), bonnet (2) and cap (3). Ensure O-ring (4) and filter screen (5) are properly installed. Reinstall cap and bonnet and tighten securely. Plug both outlets with proper fittings. Check for leaks. After testing remove shower and/or tub spout plug and flush system. Installation Instructions Brand Name: Delta Features MultiChoice® Universal valve body only; Accepts single, dual, or dual thermostatic cartridge; Cartridge ships with trim; Back-to-back capability, WS= With Stops; Trim sold separately and includes appropriate cartridge