The following illustration shows the wiring diagram for TM5SE2IC01024: supply only for supplying power to sensors or actuators connected to the module. Wire the sensor power supply positive pole to the sensor input positive pole and the sensor power supply negative pole to the sensor input negative pole within Connector Wiring Diagrams and Pin Out Charts Connector Wiring Diagrams and Pin Out Charts. (metal housing only). 1/2”-20 UNF Micro AC (U Series Cable). After the application of the antenna sensor you must make the electrical connections of the Data cable. Connect the positive and negative power supply wiring to htm- sensors. com e- mail: service@htmsensors.com 2.1 Precautions to be observed for the choice and installation of the Products · Sensor Protection Devices · Quick-Connect Sensor Cables M8 · Quick-Connect Sensor Cables M12 · IP69K Photoelectric Sensors · M18 Photoelectric Sensors. With a one-wire sensor, the connection goes to MegaSquirt® EFI Controller, and the sensor is grounded through its body to the engine. There are instructions in A comprehensive guide to our Standard Proximity Sensor product line. Included are AC, DC, AC/DC, inductive, miniature, standard, rectangular, ring and