Hi, Do you want to reset the switch to factory default configuration if yes then pelase follow below steps on last row:. or you can refer below link for HP 2920 Switches Installation and Getting Started Guide To use: connect an RJ-45 network cable to the Management port to manage an HP 5400R zl2 Switch through Telnet from a remote PC or a UNIX workstation. To use this port, the switch must have an IP address. IP settings can be configured through a Console port connection or automatically from a DHCP/ Bootp server. The following table indicates where to turn for detailed information on how. to use the individual features available through the menu interface. Option: To use the Run Setup option. To use the HP Procurve Stack Manager Chapter 14, "HP Procurve Stack Management". To view and monitor switch status and. counters. To learn how to configure and use. by Hewlett-Packard. Warranty See the Customer Support/Warranty booklet included with the product. A copy of the specific warranty terms applicable to your Hewlett-Packard products and replacement parts can be obtained from your HP Sales and Service Office or authorized dealer. Hewlett-Packard Company 8000 Foothills Boulevard, m/s 5551 yep, the screenshot above refers to hp procurve 2920 switch series installation and getting started guide (2013), the screenshot below came from the hp 2920 switch series stacking technical whitepaper (2015)i think there isn't a real difference about stacking cables placing between those two different ways (remember both are used to create a … See the HP 2920 Switch Installation and Getting Started Guide for information on supported stacking topologies. NOTE: This feature is not the stacking feature implemented on other HP Networking switches, implemented with front-panel networking cables, which does not have the high bandwidth and redundancy features of HP 2920 stacking. statements of which you should be aware when installing and using a Routing Switch. • HP ProCurve Installation and Getting Started Guide - an electronic (PDF) guide containing product safety and EMC regulatory statements as well as installation and basic configuration information. This guide is Getting Started With Switch Configuration This chapter is a guide for using the console Switch Setup screen to quickly assign an IP (Internet Protocol) address and subnet mask to the switch, set a Manager password, and, optionally, configure other basic features. For more information on using the switch console and the other switch Stack management for the 3800 switches Install a Stacking Module into an HP 3800 switch and then boot the switch, as described in the HP 3800 Switch Installation and Getting Started Guide. Make sure that stacking is enabled for the switch: Enter the show stacking command. If stacking is disabled, enter stacking enable (in global config context). Aruba 2920 Switch Series. On This Page. Legal Disclaimer: Products sold prior to the November 1, 2015 separation of Hewlett-Packard Company into Hewlett Packard Enterprise Company and HP Inc. may have older product names and model numbers that differ from current models. Hewlett Packard Enterprise believes in being unconditionally inclusive. Install a Stacking Module into an HP 2920 switch and then boot the switch, as described in the HP 2920 Switch Installation and Getting Started Guide. Make