Connect a compatible mobile device with your Phantom 3 standard via WIFI. The default password is 12341234. Go back to the app and it will ask you to activate your aircraft. Then follow the instructions in the app to name your aircraft. You can change the name later in the app if you want. Choose a Stick Mode. 7) Ready to fly. 8) Switch the Tx control mode switch to ATTI. Mode and then lightly move ESC (motor controller) State the Tx sticks in Roll, Pitch and Yaw to feel if the aircraft moves in the corresponding direction. 9) Take off the multi rotor in ATTI. Mode. 10) Finish and land the multi rotor. Converting your stock DJI Phantom 1 to a Phantom 1.5 - one of the best upgrades available for the DJI Phantom 1 - is now more affordable. The 40mm Battery Door v2.0 used for the conversion starts at just $34.99. This simple upgrade provides many benefits including more than doubling flight time, giving Phantom 1 flight times matching the newer DJI Phantom 2 and even the DJI Phantom 3. Are you planning your first flight with DJIs Phantom drone?I'll show you how to get through the first steps, start the Phantom, bring it up in the air, get f Phantom 3 SE vs Phantom 3 Standard. DJI Support - 2017-08-10. With the release of the Phantom 3 SE, you may be pondering which drone you should get out of a choice of Phantom 3 Standard $499 or the Phantom 3 SE $599. This buying guide aims to make the differences between the two of them clear so that you can How to connect DJI Phantom 3 and DJI Phantom 4 1. Download the DJI Go app (for Phantom 3) or DJI Go 4 app (for Phantom 4) on your phone and power up your drone. The Phantom 3 runs with the older version flight control app, so you should download the DJI Go app for your Phantom 3. If you're flying a Phantom 4, you should download the DJI Go 4 app. Using Phantom 4 Pro V2.0. 1. Download the DJI GO 4 App. Search for `DJI GO 4′ on the App Store or Google Play, and install the app on your mobile device. 2. Watch the Tutorial Videos. Watch the tutorial videos at dji.com or in the DJI GO 4 app. DJI GO 4 App DJI GO 4 supports iOS 9.0 (or later) or Android 4.4 (or later). 3. 1. Connect the red and black plugs of the charger cable to the charge socket. Make sure the red plug to the red charge socket, and the black plug to the black charge socket. 2. Insert the AC power cord into the charger and AC cord into a wall socket (100-240V). The charge status LED will flash green. 3. Created Date: 3/20/2015 3:19:11 PM That is going to depend largely on the gimbal you're going to use. For example, if you get a plain model Phantom 2 and later want to install a zenmuse H3-3D you will need to install both the gimbal AND open up the Phantom to install the GCU (Gimbal Control Unit) see the instructions H3-3D-GCU Connection However, when you buy the Phantom 2 with the zenmuse H3-3D the GCU comes pre-installed