the thermostat or any other control wiring and must NOT be in the same conduit as high voltage wiring. Do not use building metalwork as a ground. Use only unshielded wire. Two-Piece Installation — For two-piece installation, perform the following procedure. 1. Turn off all power to equipment. 2. If an existing thermostat is being replaced: a. Johnson Controls A19D. Johnson Controls Thermostat A19D Installation sheets manual (2 pages) Johnson Controls Thermostat A19D Product bulletin (10 pages) 4. Johnson Controls T-4002. Johnson Controls Thermostat T-4002 Control manual (8 pages) Johnson Controls Thermostat T-4002 Adjusting instructions (8 pages) 5. Johnson Controls T-4003. The control is designed for fan motors up to 1HP (120V) or 2HP (240V), with water pump and purge pump up to 2A (120V) or 1A (240V) The fan motor may be 120V or 240V rated. The water pump and purge pump motors/valves share the same electrical supply, rated for 120V or 240V. Included in Kit. Wall Control Thermostat; 2-Speed Evaporative Cooler Control and remove the Back Plate Install a 35mm deep electrical back box in your preferred thermostat location 4iE Step 1 - Install Back Plate 1 2 Before making any permanent fixtures Warmup recommends identifying your preferred location for the 4iE. It should be located in an area with good ventilation. Installation Instructions To Install Thermostat and Main Control (continued) 17. Use supplied screws to mount thermostat base to wall. 18. Insert stripped, labeled wires in matching wire terminals and tighten terminal screws once properly aligned. See the "Wiring Diagrams" section of this manual. Installation Instructions To Install Thermostat and Main Control IMPORTANT: Thermostat installation must conform to local and national building and electrical codes and ordinances. NOTE: Mount the thermostat about five feet above the floor. Do not mount the thermostat on an outside wall, in direct sunlight, behind a door or in an area affected by a How to Set Up Humidity Control on the Sensi Thermostat Installation Install humidifier/dehumidifier equipment - Wire the whole-house humidifier to the Y2/* terminal - Wire the whole-house or standalone dehumidifier to the W2/* terminal New menu items H AA and dH AA (Additional Accessory) - For wired dehumidification, select OC (Optimal Comfort) operate within limits of this device as specified in the control4 thermostat installation guide (this document) and control4 thermostat user guide. 22 awg (36 ft. max) 18 awg (100 ft. max) 24 volt or battery 1/10 w at 24 vac, 50/60 hz 41 to 104 f (5 to 40 c) 14 to 122 f (-10 to 85 c) 0 to 95% (non-condensing) 4.5 x 3.7 x 0.9 inches zigbee (ieee … The HEAT-OFF-COOL should be on OFF. AUTO-ON should be on AUTO. Remove the protective cover and find where you want your thermostat. Drill in place of mounting holes and secure the body to the wall. Use wiring diagrams in your manual to secure wire connections. Determine your type of furnace on the ELEC-GAS switch. connect the common for the accessory to common on the control board. Accessory Device Thermostat Terminals Only needed if your accessory device is self-powered. Note: You will need to congure the accessory device when you rst power on your thermostat. ACC-24V ACC+ C A14505 Fig.14--AccessoryDeviceConnection This instruction covers the installation of the Infinity Control only. Physical installation instructions for the indoor