Directions for use • The supply voltage for this product is DC12V-24V, never connect to a mains voltage. • Always connect the load first then apply the power taking care not to short circuit. • Lead wires should be connected according to the connection diagram. • Do not overload the controller. Refer to technical specifications. IRC240-S 24 Key IR Remote LED Dimmer Controller for 5050 3528 5630 Single Color $10.95 DC12-24V Single Color RF Wireless Dimmer Remote Controller Led Strip 5050 3528 $4.09 +$2.50 shipping Remote / Dimmer Controller For 5050 3528 DC12V Single Color LED Strip Lights $1.90 +$3.50 shipping Common method #1: Hold the device key for a few seconds and enter the first code listed. Common method #2: Hold the power button until the LED blinks and press the device key, followed by the The DIRECTV Universal Remote Control is designed to give you access to features and functions found on your original remote control. To use it with your brand of DIRECTV Receiver, you will need to program the remote control by per-forming the following steps. Programming DIRECTV Remote 1. Locate the DIRECTV Receiver's brand and model num- Disconnect your power source. Unplug the dimming wire from both the power supply and LED strip light (see figure 1). Remove battery from controller and then reinstall. Plug power supply and LED strip back into the receiver unit (Figure 2) Reconnect power supply to power. With the remote, hold the 'SPEED +' and 'SPEED -' buttons down Ensure the remote controller is pointed to the signal receiving window, and that there is no obstruction in between and the distance is 8m at the maximum. Do not let the remote controller drop or fling it at will. Do not let any liquid in the remote controller. Do not expose the remote controller directly to the sunlight or excessive heat. Model RT-U49E universal remote. CheckMate IV. (5) Model RT-U49C universal remote control. Scientific Atlanta Remote Codes. (5) SA2000 universal remote codes. Atlas DVR/PVR 5-Device. Cox DVR remote by Universal Electronics. How to reprogram the output of your 44/24 key LED light strip. Overtime the remote can change its own output settings. Step 1: press the red key. Step 2: press the power off. Step 3: press fade 7 (or bottom right corner button). Step 4: turn power on, repeat steps 2,3+4 until led is red. Then you have completed the tutorial and your led remote Step 2: Sniffing the Remote. The first obvious thing to do here is to sniff the IR led on the remote control. I soldered on some wires to the LED, and put the cover back on, so I could have easy access to the signal while pressing the buttons. Add Tip. Ask Question. 21Key addressable IR MINI RGB Controller Type:21 Key Remote ControllerConnection mode: Common Anode(+)Input: 5V - 24vOutput: 5VMax load current: 2A each colorOutput: three CMOS drain-open outputWorking Temperature: -20°C-60°CMode & Pattern:12 static colors.Remote controller dimension: 85mm x 52mm x 6mm ± 0.2mm Remote controller battery: 1 x CR2025 Package :1 x IR MINI RGB Controller1 x Follow the steps below to turn the remote controller on and off. 1. Press the power button once to check the current battery level. Charge the remote controller if the battery level is too low. 2. Hold the power button or press once and then hold the power button to power on the remote controller. 3. Adjust brightness, turn lights on or off, choose from 16 solid co